我发现玻璃胶已经干了，但甲醛的释放并未停止。了解到，玻璃胶在固化过程中会释放出刺激性气体，而干透之后仍然会有甲醛，因为这些挥发性有机溶剂（VOCs）是以时间为主的释放过程。因此，即使玻璃胶表面已经干燥，它内部的甲醛也可能继续释放。

关于玻璃胶凝固和干透的时间，我知道中性型号通常需要48小时才能完全干透，而酸性型号则是在24小时内就能完成。这取决于具体使用情况和环境条件。如果你正在寻找装修客源，你可以考虑自然方式，比如通过家居改善、室内植物等来吸引潜在客户。

在处理玻璃胶时，我们必须注意其粘接时间。在涂抹之前，表面应该是干燥且没有油污。如果使用分色纸覆盖某个区域，那么必须在外皮形成前移除，以免影响最终结果。硅酮类型的玻璃胶固化速度因特性的不同而异，一般建议在5-10分钟内完成对表面的修补工作。

Glassware adhesion process is as follows:

Use: Single-component silicone glass glue can be used immediately, and it can be easily applied to the surface using a gun or a scraper.

Adhesive time: The curing process of silicone glue is from the surface to the inside, and different types of silicone have different drying times and curing times. Therefore, if you need to repair the surface, you must do so before the glue dries (acidic glue, neutral transparent glue generally 5-10 minutes, neutral colorless glue generally 30 minutes).

Curing time: The curing time of glass adhesive increases with increasing thickness of adhesion. For example, an acidic glass adhesive with a thickness of 12mm may take 3-4 days to cure, but within 24 hours, only 3mm on the outside has cured.

If you're looking for decorative sources in nature, consider plants that are easy to care for and require minimal maintenance. This will not only purify your home's air but also add aesthetic value.

As for safety precautions when working with glass adhesives:

Ensure all surfaces are clean and free of oil before applying.

Avoid using solvents like acetone on plastic or rubber surfaces.

Check that metal-to-metal joints have no more than a quarter inch gap between them.

After application check all connections thoroughly before use.

Lastly note that acidic glues release acetic acid during curing which will dissipate over time leaving no odor after full cure.

I hope this information helps!